Super light, super fast, and with maximum grip, the RPM Comp 4 jump rope is specially designed for use in competitions.

The RPM Comp 4 comes with a bare steel cable without coating for maximum speed. Robustness and durability take a back seat, and performance on the comp floor has top priority. A special knurling of the super-light aluminum handles of the RPM Comp 4 jump rope ensures maximum grip and lets you never lose control of your double unders even during the most sweaty workouts.

As with Session4, RPM relies on a double ball bearing system integrated into the handle with patented dual-axis rotation. Torque build-up of the cable while jumping is thus a thing of the past.

PRODUCT DETAILS

• Dual bearing system for a smoother, freer spin
• Reinforced stem, making it our strongest rope to date
• 100% precision machined aluminum handles
• Patented dual axis rotation, allowing your handles to stay on the end of the rope while eliminating torque build up in the cable
• Aggressive knurling on the handles for maximum grip

SCOPE OF DELIVERY

• Built with clear COATED CABLE (12ft/365cm length; Length can be easily adjusted to body size

HINWEIS: To enjoy your RPM Comp 4 jump rope as long as possible, only jump on a soft surface (e.g. rubber floor). Abrasion occurs on hard surfaces (e.g. asphalt), which shortens the service life enormously. Especially the “naked” RPM Bare cable without coating should only be used on rubber floors because there is no additional “protection” by a coating. Before stowing, please wind up cable WITHOUT bending it. Abrasion due to misuse of the rope or kinking/bending due to mechanical action does not constitute grounds for complaint and is therefore not covered by warranty law.

INITIAL ASSEMBLY/ADJUSTING THE JUMP ROPE LENGTH

• Remove the tape
• Loosen the set screw on the inside handle only
• Firmly tighten the set screw of the outside handle
• Pull the handles apart
• Step on the cable with one foot and pull the handles up to upper chest hight
• Cut the cable and hold it flush with outside edge of the handle
• Push the handle to the end of the cable and firmly tighten the set screw
• Give it a test and adjust the length down as necessary

TIP: If you want to replace the cable later, you can simply determine the length using the old cable to cut the new cable down.